| FW190 GEAR |
| Other sizes available by special order. Special order means it has to be machined, not that it will cost twice as much! 80" FW190 mains & struts $275.00 90" FW190 mains & struts $325.00 100" FW190 mains & struts;$375.00 Shipping & insurance is $12 in the cont. US. Scissors are optional, and are $59.00 per set. They are not required, they are cosmetic only. Scissors are currently being redisigned. Door mounts are available at $25.00 for a set of 4. The Tailwheel assembly is also available. The 80" tailwheel is $75 for the fork assembly, $25 for the retract option, which includes a 2.5" travel cylinder, and mounting bracket. (PLEASE NOTE THE WILLIAMS BROTHERS' WHEEL IS NOT CURRENTLY AVAILABLE.... I WILL UPDATE HERE IF THEY BECOME AVAILABLE AGAIN IN THE FUTURE). Also available for 90" FW's at $85, and 100" FW's at $95. These are also available in natural finish as shown, or in blast-polish finish. The tailwheel fork can be set up to be mounted on a cylinder, or reamed to slip over a 1/8" or 3/16" wire, for a non-retract tailwheel setup, using a nosegear bearing block, for example. Email me for other sizes of gear and/or tailwheel assemblies. |
| 80" retract shown with optional scissors. |
Available for any size FW190 A, D, or Ta 152
(such as the Holman, Platt, Meister, IMP,
Baskins,Anderson). Email with your needs
Most common are 80", 90", 100", and smaller
struts and tailwheels for kits like the Topflite,
Pica, Skyshark, etc.
(such as the Holman, Platt, Meister, IMP,
Baskins,Anderson). Email with your needs
Most common are 80", 90", 100", and smaller
struts and tailwheels for kits like the Topflite,
Pica, Skyshark, etc.
FW190
tailwheel
retract
package
includes the
cylinder (2
1/2" travel
std on 80"
models),
and the
mounting
bracket
with
hardware.
tailwheel
retract
package
includes the
cylinder (2
1/2" travel
std on 80"
models),
and the
mounting
bracket
with
hardware.
Fw190 retract tailwheel shown with the
base fork. Available with whatever travel
cylinder you require. Have made these for
FW's from .60-size up to 100"..... 80"
model is usually in stock.....
base fork. Available with whatever travel
cylinder you require. Have made these for
FW's from .60-size up to 100"..... 80"
model is usually in stock.....
Gear designed to Lenny Smith's specs for the new
100" FW190D kit....... longer frames (4") to
spread the load, larger commercial cylinders, and
stiffer springs...... 74 degree retraction angle, for
"THE LOOK", also the struts use a clamp-type
strut retention setup.....
100" FW190D kit....... longer frames (4") to
spread the load, larger commercial cylinders, and
stiffer springs...... 74 degree retraction angle, for
"THE LOOK", also the struts use a clamp-type
strut retention setup.....
